Cleaning; Cleaning The Blender - Silvercrest SSML 1000 A1 Instrucciones De Uso

Cleaning

RISK OF ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block
result in you receiving a fatal electric shock and cause damage to the
appliance.
► Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
► Never disassemble the cutting blades
The cutting blades
CAUTION – PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.

Cleaning the blender

■ To prevent injuring yourself on the cutting blades
with a long-handled washing-up brush.
■ In a case of stubborn soiling, the blender
washer. To do this, always remove the blender
■ Clean the lid
normal washing up.
If you clean the blender directly after use, you can often achieve a satisfacto-
ry and hygienic level of cleaning by doing the following:
Fill the blender
detergent. Close the lid
Insert the plug into a mains power socket and activate the Ice Crush/Clean
operation a few times, so that the cutting blades
at full speed.
Afterwards, rinse out the blender
all detergent residues have been removed.
SSML 1000 A1
are extremely sharp!
and the measuring cap
with 750 ml of water and add a few drops of mild
and fit the blender
with lots of clean water to ensure that
in water or other liquids. This could
and never reach into the blender
, clean the blender
can also be cleaned in a dish-
, as described later.
in a dishwasher or with the
onto the motor block
churn through the water
GB │ IE
.
only
.
│ 31 ■