Operating - Desoutter SC2 Serie Manual De Instrucciones

6159932490_08
Series: D
Original instructions.
© COPYRIGHT 2017, DESOUTTER HP2
7SJ UK
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
This product is designed for installing and
removing threaded fasteners in wood, metal and
plastic.
The product is designed to be installed in a fixed
or mobile machine.
The risk of these motors acting as an ignition
source in a potentially explosive atmosphere is
extremely small.
The user is responsible for evaluating the risks
concerning the entire machine in which this motor
is to be installed.
No other use permitted.
For professional use only.
DATA
See page 4.
Declaration of noise and vibration emission
See page 61.
Vibration levels.
Sound levels.
: Vibration levels.
a , a
hd h
K / K = K
pA WA
L : Sound pressure level.
pA
L : Sound power level.
WA
All values are current as of the date of this
publication. For the latest information please visit
www.desouttertools.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher.
= 3 dB : Uncertainty.
The actual exposure values and risk of harm
experienced by an individual user are unique
and depend upon the way the user works,
the workpiece and the workstation design, as
well upon the exposure time and the physical
condition of the user.
We, Desoutter, cannot be held liable for the
consequences of using the declared values,
instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
An EU guide to managing hand-arm vibration
can be found at http://www.pneurop.eu/uploads/
documents/pdf/PN3-02-NV_Declaration_info_
sheet_0111.pdf
We recommend a programme of health
surveillance to detect early symptoms which
may relate to noise or vibration exposure, so that
management procedures can be modified to help
prevent future impairment.

OPERATING

WARNING: Before connecting the
tool to the air supply, check that the
pressure fitting is properly connected
or closed off.
SC2-1AM
Mount the threading accessory on the tool, and
connect the tool to the air supply. Grasp the tool
by the motor casing or secure the tool to the
machine and apply it to the fitting that needs to
be tightened. The motor starts up and tightens
the fitting to the required torque. Set the torque
by adjusting the force on the clutch spring (C).
When the torque is reached, the internal control
is disengaged and the air supply to the motor is
shut off.
SC2-2RM
This tool is designed to be connected for
clockwise or anticlockwise rotation, or switched
between the two, using appropriate valves.
WARNING: This tool starts up as soon
as the air supply is connected.
Mount the threading accessory on the tool, and
check that the tool is properly connected to the
air lines. Do not open the air inlet until the tool is
secured to the machine and applied to the fitting
to be tightened. The motor starts up and tightens
the fitting to the required torque. Set the torque
by adjusting the force on the clutch spring (C).
18 / 64
English
09/2017