OPERATING MACHINE
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Turn machine on, switch is located on back panel
of machine.
ATTENTION: If using a cleaning solution, always
test upholstery for color fastness in a hidden
place.
2. Place hand tool on spot and squeeze trigger while
pulling back on hand tool (Figure 5).
NOTE: Oversaturating upholstery can lead to
prolonged drying time.
WARNING: Flammable materials or reactive
metals can cause an explosion or fire. Do not pick
up.
3. Check recovery level periodically. When recovery
tank reaches level as shown, shut machine off and
drain tank (Figure 6).
ATTENTION: Do not continue to run machine after
recovery tank reaches level as shown. This will
damage the vacuum motor; not covered by
warranty.
Anser (06–99)
FIG. 5
FIG. 6
DRAINING RECOVERY TANK
1. Turn machine off and unplug power cord.
FOR SAFETY: Before leaving or servicing
machine, turn off machine and unplug cord from
wall outlet.
2. Disconnect vacuum hose from recovery tank.
Unfasten latches and lift recovery tank off solution
tank. Drain recovery tank completely and flush it
several times with clean water to remove all dirt
left in tank. This will prevent odor buildup
(Figure 7).
3. Tip solution tank upside down over a sink to drain
any unused cleaning solution. If you used a
chemical in solution tank, flush tank with clean
water to remove excess suds. This will prevent
chemical buildup.
MACHINE MAINTENANCE
To keep machine in good working condition, simply
follow machine's maintenance procedures.
WARNING: Hazardous Voltage. Shock or
electrocution can result. Always unplug machine
before servicing.
DAILY MAINTENANCE
1. Clean machine with a nonabrasive, nonsolvent
cleaner.
2. Rinse out tanks thoroughly.
3. Remove and clean vacuum filter.
4. Check power cord for damage – replace if
necessary. Coil cord neatly after each use.
OPERATION
FIG. 7
5