Machine Setup - Nobles Anser 608681 Manual Del Operador

OPERATION

MACHINE SETUP

1. Unfasten two latches which hold recovery tank to
solution tank. Lift recovery tank off solution tank
(Figure 1).
2. Pour up to 7.5 liters (2 gals) of hot water into
solution tank. Water temperature must not exceed
60°C (140°F). If you are only cleaning a small
spot, pour in less water. The label on solution tank
shows water level (Figure 2).
WARNING: Flammable materials can cause
an explosion or fire. Do not use flammable
materials in tank(s).
3. If desired, add liquid cleaning solution to clean
water. See proper dilution as instructed on the
cleaning solution bottle.
FOR SAFETY: When using machine, follow
mixing and handling instructions on chemical
containers.
4
FIG. 1
FIG. 2
ATTENTION: Do not mix powdered chemicals in
solution tank. Mix powdered chemicals
thoroughly in a bucket before pouring into
machine. Powders are unlikely to dissolve
completely and can clog solution pump system.
4. Replace the recovery tank onto the solution tank
and fasten the two latches.
5. Plug power cord into a grounded power outlet
(Figure 3).
Grounded
3 Hole Outlet
Ground Pin
(120V)
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord.
6. Connect hand tool hoses to extractor. Be certain
that coupler locks into extractor's couplers
(Figure 4).
7. Use Spot Remover Kit to remove as much of stain
or spot as possible (Kit sold separately #111002).
Grounded Outlet
Grounding
Edge/hole
(230V/240V)
FIG. 3
FIG. 4
Anser (10–01)