Selecting The External Component To Use; Turning On Or Off The Display Demonstration - JVC KW-XC770 Manual De Instrucciones

Selecting the external component to use

You can connect the external component to the CD changer jack on the rear using the Line
Input Adaptor KS-U57 (not supplied).
To use the external component as the playback source through this unit, you need to select
which component — CD changer or external component — to use. When shipped from the
factory, CD changer is selected as the external component.
LINE IN ON: To use the external component other than CD changer
LINE IN OFF:To use the CD changer
1 Press SEL for more than 2 seconds.
One of the PSM items appears on the display.
2 If "PSM LINE IN" does not appear, press ¢
3 Turn the control dial to select either "LINE IN ON" (external component) or "LINE IN OFF"
(CD changer).
4 Press SEL again to finish the setting.
Note:
• For connecting the Line Input Adaptor KS-U57 and the external component, refer to the
Installation/Connection Manual (separate volume).

Turning on or off the display demonstration

When shipped from the factory, this function is set to on.
With this function turned on, the unit automatically starts the following display demonstration
if no signal comes in for about 3 minutes except in the following case.
• When you turn on the unit for the first time after installation or after pressing the reset
button, it starts if no signal comes in for about 10 seconds.
If you want to turn off the display demonstration, follow the procedure below.
1 Press SEL for more than 2 seconds.
One of the PSM items appears on the display.
2 If "PSM DEMO" does not appear, press ¢
3 Turn the control dial to the left to turn off the function (or turn it to the right to turn on the
function again).
4 Press SEL again to finish the setting.
26
\
CD CASSETTE
JVC
or 4
\
or 4
repeatedly until it appears.
The current setting appears.
repeatedly until it appears.
The current setting appears.