VOX electronics ES-8112SN Manual De Usuario página 4

HOW TO ASSEMBLE THE JUICER
1. Place the Plastic Juice collector assembly on the motor housing with the spout of
right hand facing the direction of the Locking Handle. Swivel until it fits into place.
2. Place the Stainless Steel sieve assembly Firstly Ensure the white dot on blade
assembly are Correct match to the white dot on the lower coupling, then, put
down the Steel sieve into lower coupling and assemble completely.
Twist the Strainer Basket and gently push down Until it is seated in the
Juice Collector.
NOTE: The top edge of the Strainer Basket should not be higher than
the edge of the Juice Collector when properly installed.
3. Place the Pulp Chute/Juicer Cover on the top so that the opening of the Pulp
Chute is on the side opposite the spout.
4. Lock the Pulp Chute/Juicer Cover into position by raising the Locking Handle
until it clicks into the grooves located on both side of the Pulp Chute /Juicer
Cover.
NOTE: Push the Locking Handle until it is fully upright otherwise the Juice will not
operate.
1. Align the groove in the Food Pusher with the small protrusion on the inside of
the Feed Tube.
2. Slide the Pulp Container into position under the Pulp Chute.
3. Place the Juice Jug or a glass under the spout.
HOW TO PREPARE FRUIT ANd
VEGETABLES FOR JUICING
1. Wash fruits and vegetables.
2. Peel fruits that have inedible skins such as citrus fruits, pineapple, melons,
papaya, etc.
3. Pit all fruits with hard seeds or stones such as peaches, nectarines, cherries, etc.
4. Most fruits and vegetables such as apples, carrots and cucumbers will not need
to be cut, If the pieces are too big for the Feed Tube, slice the fruit or vegetables
before starting to juice.
HOW TO JUICE
1. Assemble the juicer. The Juice Jug or a glass can be placed below the pout to
collect juice.
2. Plug the power cord into a 220-240V power outlet.
3. Choose either 'Hi' or 'Lo' speed on the Electronic Control depending on the type of fruit or
vegetable that is being juiced. Never put any fruit or vegetables in the juicer until power turned
on. Soft fruit or vegetables, such as berries, melons, cucumber, tomatoes, etc, should be juiced on
Lo speed. Harder fruit and vegetables such as apples, celery, carrots, etc. should be juiced at 'Hi'
speed.
4. With the motor running, place food into the feed Tube. Using the Food Pusher, gently guide food
down the Feed Tube. To extract the maximum amount of juice, always push the Food Pusher down
slowly.
IMPORTANT: DO NOT PLACE HANDS OR FOREIGN OBJECTS DOWN THE FEED TUBE. ALWAYS USE THE
FOOD PUSHER
5. If the Pulp Container is full it can be emptied during juicing. Turn the Juicer Off and remove the
Pulp Container by holding onto the Feed Tub.
6. The froth separator in the Juice Jug will eliminate froth being poured into the glass. If you prefer to have
juice with froth, simply remove the for the separator attachment from the Juice Jug before juicing.
3