Helpful Hints; Care And Cleaning; How To Clean - VOX electronics ES-8112SN Manual De Usuario

HELPFUL HINTS

1. A small amount of lemon juice can be added to apple juice to prevent browning.
2. Do not use bananas or avocados as they do not contain juice and will clog the juicer.
3. Allow the juicer to run for one minute before turning 'Off' to allow any excess juice to be extract
from the pulp.
4. A plastic bag can be put in the pulp container for easy clean-up.
5. Disassemble the Juicer and rinse off the pulp immediately after juicing. The Strainer Basket/
Cutting Blades can be soaked in water to loosen the pulp. Then wash in warm soapy water.
6. Wash parts immediately after use to avoid discolouration of the plastic parts which may occur with
some fruits and vegetables.
7. If juicing herbs or leafy green vegetables process in combination with other fruits or vegetables to
yield more juice.

CARE ANd CLEANING

How to disassemble the Juicer
IMPORTANT: Before disassembling the Juicer make sure that the Electronic Control is in the Off position,
the plug has been removed from the wall outlet and the motor has stopped completely.
1. Remove the Food Pusher from the Feed Tube.
2. Remove the Pulp Container by holding onto the Feed Tube and tilting the juicer slightly disengage
the Pulp Container.
3. Remove the Juice Jug.
4. Hold the Pulp Chute/Juicer Cover and disengage The Locking Bar from the grooves on the side of
5. The Pulp Chute/Juicer Cover.
6. Lift and remove the Pulp Chute/Juicer Cover.
7. Remove the Plastic Juice Collector and Strainer Basket by placing one hand under the spout and
the other under the black plastic edge opposite the spout and lifting upwards. The Stainless Steel
Strainer Basket can be removed from the Juice Collector by pushing it up through the hole in the
bottom of the Juice Collector.
NOTE: Be careful when handling the Strainer Basket as the as the cutting blades are very sharp.

HOW TO CLEAN

1. Move the Control Switch to the Off position and wait for the motor to stop
completely.
2. Unplug from the wall outlet.
3. Disassemble the Juicer(see directions on page 8)
4. Clean the Pulp Container, Pulp Chute/Juicer Cover, Food Pusher,
Plastic
5. Juice Collector, Juice Jug and Froth Separator in warm, soapy water,
A mild detergent is recommended. Rinse well and dry thoroughly.
6. Hold the Stainless Steel Strainer Basket/Cutting Blades under
clean running water. Use the cleaning brush included with the Juicer
to gently clean away pulp from the filter and cutting blades. Rinse under running
water. Hold the Strainer Basket/Cutting Blades up to the light to ensure that the fine mesh holes
are not blocked. If the holes are blocked, soak the Strainer Basket/Cutting Blades in hot water to
loosen the pulp and clean with the nylon brush again. Allow to dry on a cloth or paper towel before
reassembling the juicer. Wipe the Motor Housing with a soft cloth moistened in warm soapy water.
ENVIRONMENT FRIENdLY dISPOSAL
You can help protect the environment!
Please remember to respect the local regulations: hand in the non-working electrical
equipments to an appropriate waste disposal centre.
4