Fcc Caution; Industry Canada (Ic); Intended Use - Bosch GLL3-330C Instrucciones De Funcionamiento Y Seguridad

Do not use the laser tool with Bluetooth®
in the vicinity of gas stations, chemical
plants, areas where there is danger of ex-
plosion and areas subject to blasting. Do
not use the laser measure with Bluetooth®
in airplanes. Do not use the laser measure
with Bluetooth® in the vicinity of medical
devices. Avoid operation in the direct vicin-
ity of the human body over longer periods
The manufacturer is not respon-
sible for radio interference caused
by unauthorized modifications to
this equipment. Such modifications could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful inter-
ference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class
B digital devices, pursuant to Part 15 of the
FCC rules. These limits are designed to pro-
vide reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio com-
munications. However, there is no guarantee
This device complies with Industry Canada's
licence-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference;
and
The tool is intended for determining and checking horizontal and vertical lines.
2610050360 01-18 GLL3-330CCG.indd 9
Bluetooth®
of time. When using the laser measure with
Bluetooth®, interference with other devices
and systems, airplanes and medical devices
(e.g., cardiac pacemakers, hearing aids) may
occur.
The Bluetooth® word mark and logos are reg-
istered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by Robert
Bosch Tool Corporation is under license.

FCC Caution

that interference will not occur in a particu-
lar installation. If this equipment does cause
harmful interference to radio or television re-
ception, which can be determined by turning
the equipment off and on, the user is encour-
aged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the re-
ceiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
"Exposure to Radio Frequency (RF) Signals:
The wireless device is a radio transmitter and
receiver. It is designed and manufactured not
to exceed the emission limit for exposure to
radio frequency (RF) energy set by the Minis-
try of Health (Canada), Safety Code 6. These
limits are part of comprehensive guidelines
and established permitted levels of RF energy
for the general population.

Industry Canada (IC)

(2) This device must accept any interference,
including interference that may cause
undesired operation of the device.

Intended Use

-9-
1/12/18 3:12 PM