Shark AI ROBOT RV2001EU Manual De Instrucciones página 20

MAINTENANCE
CAUTION: Turn off power before performing any maintenance.
NOTE: in the OFF (O) position, the robot still uses a small amount of power.
EMPTYING THE DUST BIN
Press the Dustbin Release Button and slide out the
dust bin.
Empty debris and dust into dust bin. Remove filter
and wash dust bin if necessary.
NOTE: Make sure to insert the dust bin completely, until
it clicks into place.
s h a r kc l e a n . e u
To open the dust bin lid, press and hold the button
while lifting the lid, using the finger slots.
Look between the filter and the plastic shield and
make sure there is no debris buildup.
Remove shield and clear any debris buildup with a
dry cloth or soft brush.
MAINTENANCE
CLEANING AND REPLACING THE FILTER
For optimal suction power, after each use, clean and reinsert the filter inside the robot's dust bin.
See sharkclean.eu for replacement filters.
Remove and empty the dust bin. Clean any hair or
debris off the Anti-Tangle Comb on the back of
the dust bin.
Lightly tap the filter to remove debris every time
you empty the dust bin. For a deeper clean, rinse
the filter with water once a month. Allow the filter
to air-dry for up to 24 hours before reinstalling.
Pull filter out of the dust bin by the tabs.
Reinsert the filter into the dust bin, then slide the
dust bin back into the robot until it clicks into
place.
s h a r kc l e a n . e u