Installing The Charger - Motorola Solutions AAM36X501 Manual De Instrucciones

Installing the Charger

When installing the charger to the wall, make sure to plan the
installation carefully.
• Leave additional space on top of the charger to attach and
detach the radio.
• The wall must be more 0.7 in. (18 mm) thick and can support
more than 8.8 lbs (4 kg).
• When installing the charger to a drywall, ensure that you use
wood reinforcement at the back of the charger. We
recommend installing the charger on the wooden board of any
size, with a thickness 0.7 in. (18 mm) or more, and attaching
this wooden board to the drywall.
1. Attach the mount jigs to the mounting holes at the back panel
of the charger.
Figure 1: Attaching Mount Jigs to Mounting Holes
2. Mark the position of the mounting screws into the wall by
pressing the charger with mount jigs against the wall. Remove
the mount jigs from the charger.
4
Mount Jigs