Getting Started; Parts And Controls; Sleep Mode - Breville PrimaLatte VCF045X Instrucciones De Uso

PARTS AND CONTROLS

1. Brewing head
2. Milk froth tube
3. Height adjustment tray
4. Drip tray and cover
5. Water tank (at rear of the unit)
6. Espresso button
7. Cappuccino button
8. Latte button
9. Froth control
IMPORTANT FIRST STEPS
Before using your Breville
1. Remove any packaging, stickers or labels.
2. Remove the water tank then remove the red shipping plug from the bottom of the tank. Discard the plug
(fig. A). The unit will not work unless you remove this plug.
3. Wash the water tank, milk tank, filter holder, filters and measuring spoon in warm soapy water. Rinse
thoroughly.
4. Fill the water tank with cold tap water (fig. B). Don't exceed the MAX marking. Refit the tank.
5. Fill the milk tank with cold tap water (fig. C). Don't exceed the MAX marking. Refit the tank. The milk
tank is a tight fit and you will have to hold the main unit in order to apply sufficent force to push it all
the way in. The Cappuccino button and Latte button lights will only come on when the milk tank is
correctly fitted.
6. Fit any one of the filters into the filter holder, then fit and lock the filter holder to the brew head—see
using the filter holder for more details. Place a large cup (approx. 250 – 300 ml) under the filter holder
(fig. D).
7. Plug your Breville PrimaLatte™ in to a power socket and set the on/off switch to ON.
®
8. The three button lights will flash slowly while the unit is heating up. Once they stop flashing and remain
lit, press and hold the Espresso button for 3 seconds. Water will flow into the cup. Wait until the water
stops flowing (the three buttons will light up).
9. Empty the cup and replace it under the filter holder. Position the milk froth tube over the cup using the
milk froth tube lever (Fig. E). Press and hold the Cappuccino button for 3 seconds. Wait until steam
and water stop flowing from the froth tube (the three buttons will light up). Your Breville
is now ready to use however, you will need to fill the milk tank with milk if you are going to make
Cappuccino or Latte drinks or use the milk frother.

Sleep mode

If you leave the unit on for 15 minutes without using it, it will go into sleep mode and the three button lights
will go out. Press any button to reactivate it.
PrimaLatte™ you need to clean it then prime it following the steps below.
®
10. Froth tube lever
11. Milk tank
12. On/off switch (on the side of the unit)
13. Single shot filter
14. Double shot filter
15. ESE pod filter
16. Filter lock
17. Filter holder
18. Scoop/tamper

getting started

PrimaLatte™
®
5