Important Preparation Suggestions - JENN-AIR CCGP2420P Instrucciones De Instalación

Installing Cabinetry Over Your
Jenn-air Grill
Minimum horizontal clearance between the edge of the
appliance and combustible construction extending from
the cooking surface to 18² (45.7 cm) above the cooking
surface is:
15/16² (2.38 cm) at rear
6² (15.24 cm) at left side
6² (15.24 cm) at right side
NOTE: This is not the recommended clearance, but
minimum allowable clearance. (See page one, "Side
Clearance".)
18²
(45.7 cm)
6²
(5.08 cm)
A = 30² (76.2 cm) minimum vertical clearance between
cooking surface and construction above the
appliance. the underside of combustible material or
metal cabinets above the cooking top must be
protected with flame retardant millboard not less than
1/4² (0.635 cm) thick.
B = 13² (33.02 cm) maximum depth of cabinets installed
above cooking top.
FIGURE 4
Dotted lines
indicate
range hood
construction
1/4² THICK FLAME
RETARDANT
MILLBOARD
FIGURE 5
Avoid use of cabinets above cooktop for storage space to
eliminate associated potential hazards such as reaching
over open flames.
*To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located
above the surface units should be avoided. If cabinet
storage is to be provided, the risk can be reduced by
installing a range hood that projects horizontally a
minimum of 5 inches beyond the bottom of the cabinets.
Preparation Of Countertop
The countertop cutout must be prepared according to the
illustration on page 1 of these instructions.
CAUTION:
Cutout dimensions are critical. Dimensions
must be measured and cut accurately to within + 1/16²
(.159 cm) to ensure proper fit.
Important Preparation
Suggestions
1. Chamfer all exposed edges of decorative laminate to
prevent damage from chipping.
2. Radius corners of cutout and file to insure smooth
edges and prevent corner cracking.
3. Rough edges, inside corners which have not been
rounded and forced fits can contribute to cracking of
the countertop laminate.
4. Countertop must be supported within 3² (7.62 cm) of
cutout.
3