Selecline 600081548 Manual De Utilización página 14

7. Lay the cabinet back on a soft pad. Unscrew the bottom hinge and levelling feet.
See Figure 7.
8. Unscrew and remove the bottom hinge pin, turn the bracket over, and replace it.
See Figure 8.
9. Install the hinge on the other side of the appliance. Replace the levelling feet.
See Figure 9.
10. Stand the appliance cabinet up and place the door into the bottom hinge. Make
sure the bottom hinge core is inserted in the door hole. Move the hinge hole
cap of the bottom door to the other side. See Figure 10.
11. Install the middle hinge. See Figure 11.
12. Place the top door in the middle hinge and replace the upper hinge.
See Figure 12.
13. Snap the hinge cover and the hole cap on the top of the unit. See Figure 13.
14. Detach the fridge and freezer door gaskets, rotate them, and reattach them.
See Figure 14.
INSTALLATION
Space Requirement
■ Ensure there is enough room to open the door to at least 90° wide.
See Figure 15.
Levelling the Unit
■ Adjust the two levelling feet at the front of the appliance for setting the level of
the appliance. See Figure 16.
Important! The appliance must be level for the doors and magnetic seal
alignments to work properly.
Positioning
Install the appliance in a location with an ambient temperature corresponding to
the climate class indicated on the rating plate of the appliance.
For refrigerating appliances with climate class:
■ Extended temperate: This refrigerating appliance is intended to be used at
ambient temperatures ranging from 10° C to 32° C (SN).
■ Temperate: This refrigerating appliance is intended to be used at ambient
temperatures ranging from 16° C to 32° C (N).
■ Subtropical: This refrigerating appliance is intended to be used at ambient
temperatures ranging from 16° C to 38° C (ST).
■ Tropical: This refrigerating appliance is intended to be used at ambient
temperatures ranging from 16° C to 43° C (T).
14