•
Please press the fan button to set the speed of the fan (high or low).
•
The corresponding speed indicator lights up, additionally, the set speed is indicated on the display using
the symbols
Dehumidification mode
•
Please press the mode button until the dehumidification mode indicator lights up.
•
The
symbol appears on the display
•
The fan speed is set automatically by the unit.
Timer
•
Please switch the unit on and set the desired room temperature and fan speed. Please switch the unit
off now.
•
Please press the timer button to activate the function. The display indicates a flashing
an amount of hours.
•
Please set the desired activation time (0-24 h) using the up/down buttons.
•
Please wait 5 seconds until the timer function is activated, the corresponding indicator light will light up
and the unit will be switched to the standby mode.
•
Please press the timer button or the On/Off button once again to clear the timer setting. The indicator
light will switch off and the timer symbol will disappear from the display.
•
Please press the timer button in the activated state of the unit to set the deactivation time as described
above.
Sleep mode
•
Please set the desired room temperature in the cooling mode.
•
Please press the sleep mode button
•
The display will be dimmed and the unit will automatically operate with a low fan speed.
•
The set temperature increases by 1 °C/1 °F per hour in a 2-hour-cycle and will be maintained for 6 hours,
then the unit will switch itself off.
Automatic mode
•
After activation of this function, depending on the ambient temperature, the unit will automatically
determine which mode (cooling, heating or fan mode) is activated.
•
Please press the mode button on the remote control several times. While the automatic mode is active,
the display will indicate spinning bars:
•
Please set the desired fan speed (high, medium or low) with the fan button.
•
When your unit is only equipped with the cooling function, it will automatically switch to the fan mode as
soon as the ambient temperature is lower than 23 °C (73 °F) and return to the cooling mode as soon as
the ambient temperature is higher than 23 °C (73 °F).
•
When your unit is equipped with both the cooling as well as the heating function, the unit will automatically
switch to the heating mode as soon as the ambient temperature drops below 20 °C (68 °F). When the
ambient temperature is between 20 °C (68 °F) and 23 °C (73 °F), the unit will switch to the fan mode.
From 23 °C (73 °F), the unit will operate in cooling mode.
Draining the water tank
The unit is equipped with an automatic water evaporation system. Condensate is used for
the cooling of the condenser, which not only increases the cooling capacity, but also saves
energy.
•
As soon as the water tank is full, the indication of
and the standby mode will activate automatically.
•
Please switch off the unit and disconnect the power plug.
•
To empty the water tank, remove the water drain plug on the bottom of the unit and
allow the water to drain into a suitable container. Alternatively, you can drain the
water using the supplied drainage hose.
•
As soon as you restart the unit, it will function completely normally.
(for high speed),
(for medium speed) and
on the remote control.
will appear on the display
(for low speed).
symbol and
20