Motorola Solutions PMPN4095A Guia De Inicio Rapido página 7

Figure 4: Mounting Multi-Unit Charger to wall bracket
Mounting Multi-Unit Charger to Wall Bracket
1. Position the wall mount bracket in the desired position, and mark the location of the
mounting holes on the wall surface.
Ensure the area behind the mounting surface is always free of electrical wires,
cables, and pipes before cutting, drilling, or installing the mounting screws.
2. Mount bracket to wall using the appropriate mounting hardware required for the type of
wall material fixture it is being mounted to. Drill based on the marked mounting holes on
the wall surfaces.
3. Secure the wall bracket in position by installing mounting hardware over the mounting
holes on the wall bracket tightly.
Note: It is recommended to use 10-16x1-1/2" tapping screw and washer (not included) on
wood stud and solid-flat concrete/brick wall.
4. Hang the Multi-Unit Charger on wall bracket as shown in Figure 4.
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or
registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other
trademarks are the property of their respective owners.
© 2016 and 2020 Motorola Solutions, Inc. All rights reserved.
Wall
Attach to
wall in four
locations
Wall
5