Ryobi A122AD2 Manual Del Usuario

AUGER REPLACEMENT DRUM
For use with RYOBI P4003 drain auger only.
WARNING
To reduce the risk of injury, user must read and understand
the operator's manual for their drain auger and this
instruction sheet. Always wear eye protection marked
to comply with Z87.1 Ensure compatibility and fit before
using this accessory. Do not use this accessory if a part
is damaged or missing.
INSTALLING THE DRUM
See Figures 1 - 3.
 Remove the battery pack or power cord from the tool.
 Hold the cable and pull the collar back.
 Remove the auger tip by sliding it out of the t-slot in the
collar.
 Place the direction of rotation selector in the OFF position.
 While holding the drum securely with one hand, pull the
drum release knob up and remove the old drum from the
tool.
 Coat the spindle of the new drum lightly with good general
purpose grease.
 Lift the drum release knob and place the new drum's
spindle into the shaft, making sure the opening on the
drum's spindle engages the bar inside the tool's shaft.
Once properly seated, release the knob to secure in place.
 Pull on the drum to ensure it is secure before operating
the tool.
INSTALLING AN AUGER TIP
See Figure 1.
 Remove the battery pack or power cord from the tool.
 Hold the cable and pull the collar back.
 Slide the auger tip into into the cable's t-slot.
 Push the collar forward so that the tip is secured properly.
Check to see that the tip is secure.
ONE WORLD TECHNOLOGIES, INC.
P.O. Box 1288, Anderson, SC 29622
Phone 1-800-525-2579
États-Unis • Téléphone 1-800-525-2579
USA • Teléfono 1-800-525-2579
www.ryobitools.com
995000687
1-2-19 (REV:01)
A122AD2
Fig. 1
A
C
A - Cable (câble, cable)
B - T-Slot (encoche en T, ranura en T)
C - Auger tip (bout du furet, punta de la barrena)
Fig. 2
A - Drum release knob (bouton se trouvant, botón de liberación)
Fig. 3
B
A
C
E
A - Drum (tambour, tambor)
B - Spindle (broche, husillo)
C - Opening (opening, opening)
D - Shaft (arbre, eje)
E - Bar (barre, barra)
B
A
D