Ultradent Products VALO CORDLESS Manual Del Usuario página 5

Mounting Bracket Instructions
1. Bracket should be mounted to a flat, oil-free surface.
2. Clean surface with rubbing alcohol.
3. Peel backing off the bracket's adhesive tape.
4. Position bracket so the curing light lifts upward when removed. Press firmly into place.
Quick Mode Guide
Mode
Power Button
Mode/Timing LEDs
Time Buttons
Time Options
To Change Time Press and release Time Button quickly to cycle through time options.
To Change Modes Press and hold Time Button for 2 seconds and release. VALO will cycle to next Mode.
Legend
Solid LEDs
Quick Curing Guide
Mode
Per Layer
Final Cure
Note: Exposure settings and times may need to be adjusted due to composite reactivity, shade, distance from the light lens to the composite, and depth
of composite layer. It is up to the dental professional to know the requirement for the material they are using to determine the adequate time and
settings.
Quick Warning Guide:
Power Level Warning
Replace batteries
• Low battery: slow flashing
• Shut off: 3 beeps, flashing
• Prohibits operation
Standard Power
5s 10s 15s 20s
Recommended Curing Times for Optimal Results with VALO
Standard Mode
One 10 second cure
Two 10 second cures
Temperature Warning
Allow for cool down
• 3 beeps
• Slow flashing
• Prohibits operation
High Power
1s 2s 3s 4s
Blinking LEDs
High Power Mode
Two 4 second cures One 3 second cure
Three 4 second cures Two 3 second cures
Service Warning LED Warning
Call Customer Service Call Customer Service
for Repair for Repair
• No sound • Continuous 3 beeps
• Flashing, 2 seconds • Single rapid flash
• Allows operation • Prohibits operations
Xtra Power
3s Only
Xtra Power Mode
5