Installation Instructions - Nordcap RRS 101 C Manual Del Usuario

INSTALLATION INSTRUCTIONS

SPECIAL INSTRUCTIONS
Current regulations require the installation of a multiple pole switch between the appliance and the electrical power supply;
•
the switch must have a contact gap of least 3 mm on each pole.
The manufacturer cannot be held liable and declines all guarantee obligations regarding any claims for damages
•
ensuing from bad installation or failure to observe current regulations.
LAWS, TECHNICAL REGULATIONS AND STANDARDS
Throughout installation it is vital to observe the following requirements:
any health and hygiene standards applicable to kitchens and eating places
•
local and/or territorial building regulations and fire prevention standards
•
current accident prevention guidelines
•
the regulations of the electrical power supply company or agency
•
any other local regulations
•
This product conforms with EU2002/96/EC compliance.
The crossed basket symbol on this product stands to indicate that cannot be disposed of through normal waste,
but should be referred to a specialized centre competent in disposal of this type of goods.
The user of such product is responsible of the disposal of this product at the end of it's life in order to avoid negative effects on the
environment.
For further information related to the disposal please contact the local authority specialized in re-cycling of these type of products.
INSTRUCTIONS FOR POSITIONING
To position counter top appliances it is advisable to use the special stand. If other systems are used, ensure that they are
•
suitable for the weight of the appliance.
If the walls next to the appliance are of inflammable material, they should be suitably clad.
•
Fire prevention regulations must be scrupulously observed.
•
The electric wiring must never be under strain. Do not obstruct the suction inlets or heat dispersion outlets; scrupulously
•
follow the installation diagrams.
Remove the protective film.
•
INSTRUCTIONS FOR ELECTRICAL CONNECTION AND UNIPOTENTIAL SYSTEM
The electrical safety of this appliance is guaranteed only if it is connected correctly to an efficient earthing system, in accordance
with current safety regulations. The manufacturer shall not be responsible for any damage caused by failure to earth the installation
properly.
The appliance must also be included in a unipotential system. Make the connection through the terminal situated on the rear of
the appliance, and marked by the relevant symbol, according to current safety regulations.
SAFETY AND CONTROL SYSTEMS
Room safety thermostat
Power circuit protection
Auxiliary circuit switch
Intervenes in the event of a malfunction of the main temperature regulating thermostat to
ensure that the machine room temperature does not exceed the authorised limits
A remote control switch protects the power circuit
Fuses positioned next to the terminal board protect the electric circuit
9
GB
Ed. 0314