Installation Instructions - Nordcap HHB 048 Manual De Instrucciones

INSTALLATION INSTRUCTIONS

INSTRUCTIONS FOR POSITIONING
•
If the walls next to the appliance are of inflammable material, they should be suitably clad.
•
Fire prevention regulations must be scrupulously observed.
•
The electric wiring must never be under strain. Do not obstruct the suction inlets or heat dispersion outlets; scrupulously
follow the installation diagrams.
•
Remove the protective film.
INSTRUCTIONS FOR ELECTRICAL CONNECTION AND UNIPOTENTIAL SYSTEM
The electrical safety of this appliance is guaranteed only if it is connected correctly to an efficient earthing system, in accordance
with current safety regulations. The manufacturer shall not be responsible for any damage caused by failure to earth the installation
properly.
In case of replacement of the power cord, the length of the wires between the connection point of the cable and the terminals must
allow the active conductors to be tightened before being earthed.
SAFETY AND CONTROL SYSTEMS
Auxiliary circuit switch
Restoring the safety thermostat If during machine use, this should switch off due to the safety thermostat intervening, you can
Fuses positioned next to the terminal board protect the electric circuit
reset it. The position of the safety thermostat that is to be reset is indicated on the rear of the
machine. Unscrew the screw to access the reset button of the thermostat inside the machine.
Use the tip of a tool to enter the reset hole and push slightly. Then tighten the screw again.
10
GB
Ed. 0314