Sears Kenmore PRO 790.79623 Manual Del Usuario página 25

general Care & Cleaning (cont'd)
Cleaning the grates
The burner grates are dishwasher safe and may be cleaned in the dishwasher. Remove any excessive soils before
placing in the dishwasher.
IMPOrTAnT
● For proper gas fl ow and ignition of the burners — DO NOT allow spills, food, cleaning agents or any other material to
enter the gas orifi ce opening.
● The cooktop is not removable. Do not attempt to remove or lift the cooktop.
To avoid possible burns use care when cleaning the cooktop. DO nOT attempt to clean the cooktop
whenever the cooktop or burner heads are still hot.
To avoid possible burns DO nOT attempt any of the following cleaning instructions provided before
turning OFF all of the surface burners and allow them to cool.
To avoid possible burns DO nOT attempt to operate the surface burners without the burner caps
Your appliance is shipped with the burner heads and burner caps in the correct locations. Before using your gas
appliance be sure to:
● Follow installation instructions before operating.
● Remove all packing tape from cooktop area.
Cleaning the burner caps
Should you ever need to remove the burner caps for cleaning, lift the burner cap off the burner head. Clean heavy
soils with an absorbent cloth. Rinse with a clean, damp cloth and immediately thoroughly dry including the bottom and
inside of the cap. Do not use harsh abrasive cleaners. They can scratch the porcelain on the cap. Do not clean burner
caps in dishwasher.
IMPOrTAnT - When placing the burner caps on the cooktop, be sure the burner caps are seated firmly on top of
burner heads. Improper flame size and uneven heating may result when any surface burners are turned ON and the
burner caps are not seated correctly
Cleaning the burner heads
Lift the burner cap from the burner head. The surface burner
heads are secured to the cooktop and must be cleaned in place
(except for the bridge burner, which is removable. See bridge
burner assembly section for proper installation).
For proper gas fl ow it may be necessary to clean the burner heads
and slots. To clean, fi rst use a clean DAMP cloth to soak up any
spills. Remove any food from between the burner slots using a
small nonabrasive brush like a toothbrush and afterwards wipe
using a damp cloth. For stubborn soils located in the slots, use a
small-gauge wire or needle to clean.
Should you experience ignition problems it may be that an ignition
port hole is partially blocked with soil (see fi gures 1 & 2). With the
burner head in place, use a small wire gauge needle or the end of
a paper clip to clear the ignition port or ports.
Slots
Figure 1 - Cooktop burner head
(All burners except Double ring burner)
Orifi ce port
Figure 2- Dual ring burner head
(Models equipped with double ring burner only)
25
Ignition port
Orifi ce port
Slots
Ignition
port
Orifi ce
port