Before Setting Surface Controls
Check Burner Cap Placement Before
Operating the Surface Burners
Double ring Style Burners
The Double Ring burner only operates properly with two
burner caps in place. Be sure the burner cap lips are
positioned facing down towards the burner head (Fig. 1) and
into the recessed areas (Fig. 2) on each side of the burner
head. Be sure both burner caps are seated firmly and rest
level on the burner head before operating.
Check the fit for each cap by gently sliding each cap from
side to side. Please note that the burner cap lips should NOT
move out of recessed areas of the burner head.
Bridge Style Burners
Install Burner Caps, these include one Bridge Burner Center
Cap (rectangular shaped) and the two Bridge Burner End
Caps (The Bridge Burner End Caps will fit either the front
or rear Bridge Burner Head locations). Make sure that the
lips located under the Bridge Burner Caps fall into the slots
located in the Bridge Burner Head (See arrows in Figure 3)
and that all the Bridge Burner Caps lie flat and evenly on the
Bridge Burner Head.
Burner Caps
recessed
area
Burner
Head
Bridge Burner Head
Bridge
Bridge
Burner
Burner
End
End
Cap
Cap
Bridge
Bridge
Burner
Burner
Center
Center
Cap
Cap
Bridge
Bridge
Burner
Burner
End
End
Cap
Cap
8
Fig. 1
Fig. 2
Bridge Burner Head
Igniter
Igniter
Hole
Hole
Igniter
Igniter
Hole
Hole
Fig. 3