Using The Griddle; Before Setting Oven Controls - Sears Kenmore PRO 790.79623 Manual Del Usuario

Surface Cooking
Care & Seasoning of the griddle
Before first use:
• Wash Griddle in hot soapy water. Rinse and then dry completely.
• Apply a thin coat of vegetable oil to the entire surface (front and back of griddle).
• Preheat your oven to 350°F. Place the griddle on the upper rack in your oven.
• Bake griddle for 1 hour at 350°F, then turn oven OFF and let cool before
removing.
• The surface may appear to have a tacky feel to it from the seasoning process. If
desired, wash the griddle in hot soapy water, rinse well, and dry completely.
After each use:
• To prevent rusting, store in a dry place and keep uncovered.
• After each use, clean with a stiff brush and hot water only.
• DO nOT CLEAn grIDDLE In DISHWASHEr.
• Dry Immediately and apply a light coating of vegetable oil to griddle before
storing.

Using the griddle:

• Center either side of the griddle over the Bridge Burner (See Figure 1).
• Preheat the griddle for 5 minutes on medium to medium low setting. Slow
preheat ensures even heat distribution during the cooking process.
• DO NOT preheat the griddle on HI setting. Preheating on HI may warp the
griddle and prevent even heat distribution.

Before Setting Oven Controls

IMPOrTAnT : This range has a fan that will turn "On" and "OFF" by itself to keep the electronics cool. It may continue
to run after the range has been turned "OFF", but may also stop immediately and then turn "On" after a while.
Oven vent Location
The oven vent is located at right side of the front panel
and visible when the oven door is open. When the oven
is on, hot air is released through the vents. This venting is
necessary for proper air circulation in the oven and good
baking results.
Left Rear Left Rear Center Front
200
Center Rear Right Rear Right Front
350 OvEn vEnT
300 400
250 450
500
Warm & Broil
Hold F Clean
removing and replacing Oven racks
To remove, pull the rack forward until it stops. Lift up
front of rack and slide out. To replace, fit the rack into
the guides on the oven walls. Tilt the front of the rack
upward and slide the rack back into place.
13
Figure 1