Festool KA 65 Manual De Instrucciones página 17

– Setpoint temperature
– Units of measurement
If no menu buttons are pressed within 10
seconds, the menu is closed automatically
and the changes are discarded.
Mode button
MODE
Press the button to select the
value you wish to change
(flashes).
Arrow buttons
The selected value can be
adjusted.
OK
OK
Press <OK> to save any
changes.
7.5 Display[1-20]
The current settings and information graphics are
shown on the display [1-20].
Temperature selection [1-7]
1 2
Setting 1 (190 °C) / Setting 2
(200 °C)
Feed speed[1-2]
1st gear (2 m/min) / 2nd gear
(4 m/min)
Units of measurement
°C/m, °C/ft, °F/ft, °F/m
Select from °C/m, °C/ft, °F/ft or
°F/m.
°C = degrees Celsius
m = metres
°F = degrees Fahrenheit
ft = feet
Remaining edge length
33,0 m
Edge band length in relation to
the remaining quantity of adhe-
sive.
Adhesive quantity
Setting for the required adhe-
sive quantity.
Actual and setpoint tempera-
130 190 °C
ture
Display [1-20] lights up red
during heating mode.
Setpoint temperature
190 °C
Ready for operation, display [1-
20] lights up green.
**
2
190 °C
MODE
KA 65
Refill button [1-21] pressed
Adhesive feed is reversed for
refill process.
Open flap [1-18]
Adhesive feed was reversed for
refill process. Flap [1-18] can
be opened.
Insert adhesive cartridges
The magazine can be refilled
with adhesive cartridges.
Close the flap [1-18]
Work can continue after the flap
[1-18] is closed.
Refill process complete
Adhesive feed moves forward
and pressure builds in the
adhesive cartridges.
Edge inlet ready
Guide the edge band into the
edge inlet [1-11] within 20 sec-
onds. The remaining time is dis-
played. If the edge band is not
inserted within the specified
time, the start button [1-1]
must be pressed again.
Edge band to start position
Now press the start button
[1-1] to glue the edge band. The
inlet starts up and transports
the edge band through the
machine.
Remove the edge band
An edge band was detected
when the machine was switched
on. Request for removal of the
edge band. Press the start but-
ton [1-1] and hold until the edge
band has passed through.
Purging position reached
Central plate [1-12] has been
lowered completely and moved
to purging position.
Purging process starts
Start button [1-1] was pressed.
The purging process starts after
one second.
GB
17