EngLIsh
OPERATION
WARNING! Do not place the laser in a position which may cause anyone to
intentionally or unintentionally stare into the laser beam. Serious eye injury may
result from staring at the beam.
Instructions for Use
WARNING: Always observe the safety instructions and applicable regulations.
•
Always mark the center of the laser dots.
•
Make sure the tool has been set up securely.
•
Extreme temperature changes cause movement of internal parts that may affect
the accuracy of the tool. Regularly check the accuracy while using the tool under
these circumstances.
•
Although the tool corrects small out-of-level errors automatically, when it is bumped,
re-adjustment to balance or set-up may be required.
•
If the tool has been dropped or has tipped over, check whether there is damage by
performing the field calibration checks. See Maintenance.
Switching On and Off (Fig. A)
The tool has separate switches to operate the vertical laser line and the horizontal laser line.
•
To switch the vertical laser beam
•
To switch the horizontal laser beam
•
To switch either laser beam off, press the on/off switch again.
Transferring a Position Mark (Fig. D)
The tool produces two laser lines in horizontal and in vertical direction, to transfer a mark.
•
Align the relevant laser beam with the mark.
Rotating the Tool (Fig. E)
When in wall set-up, the tool can be rotated manually to transfer the horizontal laser line.
•
Rotate the tool to the left or right as required.
48
on, press the on/off switch
4
5
on, press the on/off switch
.
1
2
.