Assembly And Adjustment - DeWalt DW088 Manual Del Usuario

EngLIsh
1/4" x 20 female thread
11
Intended Use
The crossline laser DW088/DW088CG has been designed to project laser lines to aid in
professional applications. The tool can be used indoor for horizontal (level), vertical (plumb).
The applications range from layout of walls and windows to installation of framing track.
DO nOt use under wet conditions or in presence of flammable liquids or gases.
The crossline laser is a professional tool. DO nOt let children come into contact with the
tool. Supervision is required when inexperienced operators use this tool.
• This product is not intended for use by persons (including children) suffering from
diminished physical, sensory or mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their safety. Children should
never be left alone with this product.

ASSEMBLY AND ADJUSTMENT


WARNING: Do not place the laser in a position which may cause anyone to
intentionally or unintentionally stare into laser beam. Serious eye injury may
result from staring at the beam.
Replacing Batteries (Fig. B)
The attachment uses batteries of type LR6 (AA).
• Open the battery compartment cover
• Replace the batteries
• Close the battery compartment cover.

WARNING: When replacing batteries, always replace the complete set. Do not mix old
batteries with new ones. Preferably use alkaline batteries.
Low Battery Indicator (Fig. A)
The tool has been equipped with a low battery indicator
The low battery indicator is lit while the tool is switched on. It will blink to indicate that the
batteries need to be replaced and the tool will automatically shut down.
• Switch off the tool and remove the batteries as soon as the indicator blinks.
Setting up the Tool (Fig. C1 - C4)
The tool facilitates various set-ups, making it useful for several applications.
Floor set-up
• Place the tool on a relatively smooth and level surface.
46
10
12 . Make sure the new batteries are placed as indicated .
.
located on the control panel.
3