Optional Accessories - DeWalt DW088 Manual Del Usuario

EngLIsh
Bright light shining on detector causes continuous "on-grade" signal.
• In the presence of very intense ambient light, the detector may give a false or erratic
indication of level.
• Reposition the detector out of the intense light or shade the sensor window
resume normal operation.

Optional Accessories

Using the Laser with Accessories (Fig. 1 inset)
The laser is equipped with a 1/4" x 20 female thread
This thread is to accommodate current or future D
accessories specified for use with this product. Follow the directions included with
the accessory.
Consult your dealer for further information on the appropriate accessories.These are:
DE0734 D
e
DE0737 D
e
DE0881 D
e
DE0882 D
e
DE0892 D
e
MAINTENANCE
Your D WALT laser unit has been designed to operate over a long period of time with a
e
minimum of maintenance. Continuous satisfactory operation depends upon proper laser
care and regular cleaning.
Field Calibration Check (Fig. H–J)
The field calibration check must be performed securely and accurately to make a
correct diagnosis. Whenever an error is registered, have the tool serviced by a qualified
repair agent.

WARNING: The conditions of the area are indicative of the results presented.
If the practice differs from these conditions, the measurements have to be
adjusted accordingly.
Scan Check (Fig. H)
• Place the tool in an area between two vertical surfaces that are at least 9 m apart.
Mount the tool exactly midways to the wall.
• Position the tool at an angle of 45° to the left.
• Switch on the horizontal laser beam.
• Mark the centre of the laser beam exactly midways on the opposite wall.
52
WALT grade rod
WALT grade rod
WALT tripod
WALT laser pole
WALT detector
11 on the bottom of the unit.
WALT accessories. Only use D
e
25 to
WALT
e