Tripp-Lite SmartPro 450 RT El Manual Del Propietario página 4

Connection
Plug one end of the
1
detachable line cord
into your UPS's AC
Inlet Receptacle and
the other end into an
electrical outlet.
Plug your computer,
2
monitor and other
critical devices into your
UPS's Battery-Supported
Receptacles.*
Plug a printer or other
peripheral equipment
into your UPS's Surge-
Only Receptacle.
–Optional–
Using Tripp Lite cable, connect
the serial port of your computer
to the serial port of your UPS.**
Load software and run
installation program appropriate
to your operating system.
Turn your UPS ON
3
by pressing the Main
Power Switch, holding
it for 3 seconds and
releasing it.***
* Your UPS is designed to support only computer equipment. You will overload your UPS if you connect household
appliances, laser printers or surge suppressors to the UPS's Battery-Supported Outlets. ** DB9 port connection is
optional. Your UPS will function properly without this connection. *** The UPS will execute a 10-second self-test.
The "Normal" LED will illuminate and the UPS will emit one beep to indicate normal operation.
4