Publicidad
Chapter 1. Controls
1.1.
Controls on Mark VI Non-Tilting Washer-extractors
(Document BICWCO02)
1.1.1.
Where are the Controls?
1.1.2.
Where do I Connect the Data Storage Device?
1.1.3.
What are the Operating Controls?
1.1.4.
What does this Switch do?
Chapter 2. Normal Operation
2.1.
Operating Instructions for Plant Personnel
BICWCO03)
2.1.1.
Start Here for Safety
2.1.2.
Check Switch Settings
2.1.3.
How do I Load a StaphGuard
2.1.4.
How do I Select a Formula?
2.1.4.1.
Selecting a Local Formula
2.1.4.2.
Selecting a Mildata Formula
2.1.4.3.
Entering Mildata Batch Codes
2.1.5.
Start the Selected Formula
2.1.6.
What Does the Run Display Tell Me?
2.1.6.1.
Formula and Step Information
2.1.6.2.
Basket Rotation
2.1.6.3.
Bath Temperature and Level
2.1.6.4.
Formula Steps and Chemical Injection
2.1.7.
Unload the Machine
Table of Contents
Sections
®
Machine?
175
Figures, Tables, and Supplements
Figure 1: Locations of Controls
Figure 2: Serial Connection for Data
Transfer
Figure 3: Mark VI Staph Guard Soil Side
Controls
Figure 4: Keypad
Figure 5: Typical Staph Guard Clean Side
Controls
Figure 6: Mildata/Local Selector switch
Figure 7: Manual Supply Flush button
Figure 8: Autospot selector switch
(Document
Figure 9: Selecting a Local or Remote
Formula
Figure 10: Select Local Formula Screen
Supplement 1: About Load Weight and
Metered Water
Figure 11: Entering Load Weight for
Metered Water
Figure 12: Select Remote Formula Screen
Figure 13: Batch Data for Remote Formula
Operation
Supplement 2: Chemical Injections with
the Operator Signal
Figure 14: How to Read the Run Display
Table 1: Machine Status Messages
Figure 15: Typical Message when Formula
Ends
Table of Contents
PELLERIN MILNOR CORPORATION
Publicidad
Capítulos
