Additional Safety Instructions; Noise And Vibration - Flex L 3709-115 Instrucciones De Funcionamiento Originales

 Support plates or large workpieces
to prevent the risk of a kickback due
to the cutting-off wheel jamming.
Large workpieces may sag under their own
weight. The workpiece must be supported
on both sides of the wheel, namely near
the separating cut and along the edge.

Additional safety instructions:

 The mains voltage and the voltage speci-
fications on the rating plate (9) must
correspond.
 Do not press the spindle lock (4) until
the grinding tool stops.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool
is typically:
Sound pressure
level dB(A)
Sound power
level dB(A)
Uncertainty
K (dB)
Total vibration value (when sanding surfaces):
Emission value
2
a (m/s )
h
Uncertainty
2
K (m/s )
18
L 3709 -115, L 3709 -125, LE 9-10 125, L 10-10 125, L 800, L 1000
LE 9-10 L 3709/ L 10-10
125 L 800 125/
L 1000
87 84.6
98 95.6 102
3 3
LE 9-10 L 3709/ L 10-10
125 L 800 125/
L 1000
6.5 6.5
1.5 1.5
Total vibration value (when cutting):
Emission value
a (m/s
h
Uncertainty
K (m/s
qÜÉ=áåÇáÅ~íÉÇ=ãÉ~ëìêÉãÉåíë=êÉÑÉê=íç=åÉï=
éçïÉê=íççäëK=a~áäó=ìëÉ=Å~ìëÉë=íÜÉ=åçáëÉ=~åÇ=
îáÄê~íáçå=î~äìÉë=íç=ÅÜ~åÖÉK
The vibration emission level given in this infor-
mation sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one
tool with another. It may be used for a
preliminary assessment of exposure. The
declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different appli-cations, with
91
different accessories or poorly maintained, the
vibration emission may differ. This may
significantly increase the exposure level over
the total working period.
For a precise estimation of the vibration load the
3
times should also be considered during which
the power tool is switched off or even running,
but not actually in use. This may significantly
decrease the exposure level over the total
working period. Identify additional safety
measures to protect the operator from the
effects of vibration such as: maintain the tool
and the accessories, keep the hands warm,
6.6
organisation of work patterns.
tÉ~ê=É~ê=éêçíÉÅíáçå=~í=~=ëçìåÇ=éêÉëëìêÉ=
1.5
~ÄçîÉ=UR=Ç_E^FK
LE 9-10
125
8.1
2
)
1.5
2
)
t^okfkd>
klqb
`^rqflk>
L 3709/ L 10-10
L 800 125/
L 1000
6.3 6.2
1.5 1.5