Additional Safety Instructions; Noise And Vibration - Flex SE 125 18.0-EC Instrucciones De Funcionamiento Originales

 Use special care when working corners,
sharp edges etc. Avoid bouncing and
snagging the accessory. Corners, sharp
edges or bouncing have a tendency to
snag the rotating accessory and cause loss
of control or kickback. This causes a loss of
control or kickback.
 Do not attach a saw chain woodcarving
blade or toothed saw blade. Such blades
create frequent kickback and loss of
control.

Additional safety instructions

WARNING!
Touching or inhaling harmful/toxic dust is a
hazard to the operator and to people in the
vicinity.
 It is not recommended to sand lead paint.
Lead paint should be removed by a specia-
list only.
 Do not work on materials which release
hazardous substances (e.g. asbestos).
Take precautions if hazardous,
combustible or explosive dust is likely to
occur. Wear protective dust mask.
Use dust extraction system.
DAMAGE TO PROPERTY!
The mains voltage and the voltage
specifications on the rating plate must
correspond.

Noise and vibration

WARNING!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this infor-
mation sheet has been measured in accor-
dance with a standardised test given
in EN 60745 and may be used to compare
one tool with another. It may be used for a
preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different appli-
cations, with different accessories or poorly
18
maintained, the vibration emission may differ.
This may significantly increase the exposure
level over the total working period.
For a precise estimation of the vibration load the
times should also be considered during which
the power tool is switched off or even running,
but not actually in use. This may significantly
decrease the exposure level over the total
working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
SE 125 18.0-EC