Uline H-1649 Manual De Instrucciones página 5

mAnuAl AccumulAtIOn
When the scale is set for manual accumulation:
1. Press the Acc key to store the displayed weight in
the memory when the weight is stable.
2. display shows 'Acc 1' and then the total stored in
memory for 2 seconds before returning to normal.
3. remove the weight and allow the scale to return to
zero, then add a second weight.
4. Press Acc, the display shows 'Acc 2' and the new total.
5. continue to remove and add weights and press
Acc until all weights have been added.
6. to view the totals in memory, press Acc when the
scale shows zero. the display shows the total number
of items 'Acc xx' and the total weight and then
returns to zero.
To clear the memory:
1. Press Acc to display the totals.
2. Press the Func/c key to clear the memory.
NOTE: ACC function is only available when the
stable indicator 'O' is on.
to set functions, press the Func and Acc keys at the same
time. scroll through functions by pressing %/< or lImIt/>
— the scale will go through the functions in this order:
cHAnGE scAlE WEIGHt IncrEmEnt
to minimize effects of vibration, wind or other conditions:
• Example: If scale normally weighs in increments of
0.5g, the value can be changed to 1.0g or 2.0g to
get a more stable reading.
1. display shows 'Inc xx'. the first value shown is the
default weight increment.
2. Press the tArE/^ key to change the default.
3. Press ZErO/EntEr to set the new weight increment.
BAcKlIGHt cOntrOl
usually backlight is set to operate automatically, turning
off when the scale is not being used.
• turning the backlight off helps maximize battery life.
PAGE 5 OF 18
OPERATION CONTINUED
AutOmAtIc AccumulAtIOn
When scale is set for Automatic Accumulation:
1. Add a weight to the scale. the beeper sounds when
2. display shows 'Acc 1' and totals the memory when
3. Add the next weight to continue the process.
4. Press Acc to display the accumulated totals.
5. to return to normal weighing mode, turn Au off.
FUNCTIONS
1.
2. Press ZErO/EntEr to set your selection.
AccumulAtEd tOtAl
scale can be set to accumulate manually or
automatically. (refer to AccumulAtEd tOtAl in
OPErAtIOn section.)
cHAnGE tHE BAud rAtE
display shows 'b xxx'; this is the current baud rate.
1.
2. Press ZErO/EntEr to set your selection.
AutO ZErO rAnGE trAcKInG
set to 0.5d, 1d, 2d and 4d.
1.
2. Press ZErO/EntEr to set your selection.
the weight is stable to indicate the weight is added.
remove the weight.
the scale returns to zero.
NOTE: While a weight is on the scale, you can
also press ACC to store the value immediately.
In this instance, the scale will not store the
value when the weight is removed.
NOTE: The scale must return to zero or display
a negative number before another sample
can be added to the memory. More items can
be added and ACC pressed again, up to 99
entries or until you exceed the weight capacity
displayed.
Press tArE/^ to select 'El On' (manual on), 'El Au'
(automatic on/off), or 'El Off' (turns off backlight).
Press tArE/^ to select: 600bps, 1200bps, 4800bps or
9600bps.
Press tArE/^ to select.
0613 IH-1649