Preparing Music Or Sounds; Changing The Music; Changing The Sounds; Restoring The Memory Card - marklin 43868 Manual De Instrucciones

Preparing Music or Sounds

The electronic circuit built into the car can only play back
files in the WAV format, with 16 kHz sampling rate, 16 bit
sampling in mono. However you can also have any other
music file converted on the memory card from other acces-
sible formats as described below.

Changing the Music

1 Remove the micro-SD memory card from the car.
2 Connect the memory card to a Windows® PC.
3 Open the folder „Converter" on the memory card.
4 Select the desired pieces of music and use the mouse to
transfer them to the file „DATEI_HIER_DRAUFLEGEN".
5 The transfer will start. The files are converted in the
process and are stored on the memory card.
The music is stored on the memory card in the folder
„Musik". You can delete existing or newly entered pieces of
music as desired.

Changing the Sounds

Sounds are stored on the memory card in the folder „Ge-
räusche". Here you can place any other sounds or delete
existing ones.
A maximum of only 5 sounds can be stored.
The easiest thing to do is to proceed as described for music
and then position the sounds in the right folder. Please note
that the new sounds must replace the previous ones and
must have their names.

Restoring the Memory Card

The reproduction of music or sounds assumes certain fol-
ders on the memory card. If the card should be formatted or
replaced, the necessary folder structure can be generated
again from a ZIP file. See under „Downloads" at
www.maerklin.de for this.
9