Vega WEIGHTRAC 31 Instrucciones De Servicio página 80

11 Anexo
Mapping of Process Value Status
Hex Quality
0x00 Bad
0x01 Bad
0x0C Bad
0x10 Bad
0x1C Bad
0x20 Bad
0x44 Uncertain
0x48 Uncertain
0x4C Uncertain
0x80 Good (NC)
Mapping of User Error Codes to FF Field Diagnostics
Priority Description
31 Hardware failure
30 Memory failure
29 Software failure
28 Paramererization corrupt
27 Undefined 27
26 Undefined 26
25 Paramererization error
24 Conflict in MGC
23 Communication error in MGC
22 MGC slave reports error
21 Undefined 21
20 Undefined 20
80
Sub-Status
Non-specific
Configuration Error
Device Failure
Sensor Failure
Out of Service
Transducer in MAN
Last Usable Value
Substitute
Initial Value
Non-specific
User Error Codes
40, 41
34, 35, 36, 37
80
72
-
-
16, 17, 25, 52, 53, 57, 66, 117,
120
121, 122, 141
8
38
-
-
Condition
Unexpected error
It was tried to set a wrong unit with FF interface
On user error codes: 16, 17, 25, 52, 57, 66, 72,
117, 120
Five or more internal communications have failed
while "Process Data Update". Last usable value is
displayed
On user error codes: 8, 34, 35, 36, 37, 38, 73, 80,
86, 121, 122, 141
On user error codes: 40, 41, 53, 68, 123, 124, 125
Transducer block is in mode "Out of Service"
Channel is not assigned to an AIFB
Channel is not available in running application
Transducer block is in mode "Manual"
Three or more internal communications have fai-
led while "Process Data Update". Last usable value
is displayed
On user error codes: 29
After startup of device or channel assignment in
AIFB was changed. The channel unit may be unk-
nown until next "Process Data Update"
On user error codes: 13
No errors concerning to channel handling
On user error codes: 0, 33, 45, 71, 126, 127
WEIGHTRAC 31 • Foundation Fieldbus
NE-107 Status
FAILURE
FAILURE
FAILURE
FAILURE
-
-
FAILURE
FAILURE
FAILURE
FAILURE
-
-