Husky Y1010 Manual Del Operador página 15

How to use High Flow
Inflator/Deflator Adapter Body
1. Assemble the high flow
inflator/deflator body as
described in the Assembly
section.
2. Choose nozzle to be used to
inflate or deflate. NOTE: The seal
ring may be used with any of the
nozzles to prevent air from leaking
out of inflatables with very large air
inlets.
3. The high flow inflate/deflate
adapter body attachment has an
"inflation" outlet and "deflation"
outlet. Attach the nozzle to the
preferred outlet. NOTE:
"Inflation" and "Deflation" are
marked at outlets.
Nozzle
attached to
"deflation"
outlet
Nozzle
attached to
"inflation"
outlet
4. Insert nozzle into inflatable and
then start inflator, see "How to
Start" paragraph.
NOTE: If inflatable is not getting firm
enough, place thumb over the
"deflation" outlet to allow air to go
directly into the inflatable.
inflate. Keeping thumb over
"Deflation" outlet could cause
inflatable to over-inflate. Use
caution when placing thumb over
"Deflation" outlet.
15- ENG
Risk of Bursting.
DO NOT over-
A05051