Husky Y1010 Manual Del Operador página 13

Regulator: Controls the air pressure
shown on the outlet pressure gauge.
Turn knob clockwise to increase
pressure and counterclockwise to
decrease pressure.
Female Tire Chuck: Attaches to the
hose end to be used to inflate tires.
Note: To ensure correct tire pressure
use a tire pressure gauge.
Blow Gun: Ideal for blowing,
cleaning, and inflating. Depress lever
on to release the air. Attaches to hose
end.
Safety Nozzle: Prevents pressure
build-up. Attaches to blow gun outlet.
Blow Gun Adapter: Attaches to the
blow gun to allow the tapered Inflator,
inflating needle, or high flow
inflator/deflator adapter body to be
used.
Inflating needles: Used to inflate
sport balls. Requires blow gun
adapter.
Tapered Inflator: Used to inflate toy
inflatables/air mattresses. Brass
tapered inflator attaches to blow gun
outlet and plastic tapered inflator
requires the blow gun adapter.
Rubber Tip Nozzle: Used to inflate
toy inflatables/air mattresses.
Attaches to blow gun outlet.
High Flow Inflator/Deflator Adapter
Body: Used with inflator/deflator
nozzles it attaches directly to the
universal valve adapter to inflate or
deflate air mattresses, small boats,
inflatable toys, and other inflatable
items that use a large volume of low-
pressure air. Requires blow gun
adapter.
Inflator/Deflator Nozzles: Used with
the high flow inflator/deflator adapter
body.
Seal Ring: Used with inflator/deflator
nozzles to prevent air from leaking out
of inflatables with very large air inlets.
Drain Valve (not shown): The drain
valve is located at the base of the air
tank and is used to drain
condensation at the end of each use.
Cooling System (not shown): This
compressor contains an advanced
design cooling system. At the heart of
this cooling system is an engineered
fan. It is perfectly normal for this fan
to blow air through the vent holes in
large amounts. You know that the
cooling system is working when air is
being expelled.
Air Compressor Pump (not shown):
Compresses air into the air tank.
Working air is not available until the
compressor has raised the air tank
pressure above that required at the
air outlet.
Check Valve (not shown): When the
air compressor is operating, the
check valve is "open", allowing
compressed air to enter the air tank.
When the air compressor reaches
"cut-out" pressure, the check valve
"closes", allowing air pressure to
remain inside the air tank.
How to Use Your Unit
How to Stop:
1. Set the Off/Auto-On switch to
"Off".
Before First Start-up
Break-in Procedure
damage may result if the following
break-in instructions are not
closely followed.
This procedure is required before the
air compressor is put into service.
1. Make sure the Off/Auto-On
switch is in the "Off" position.
2. Turn the regulator knob
counterclockwise until it stops.
3. Plug the power cord into the
correct branch circuit receptacle.
(Refer to Voltage and Circuit
Protection paragraph in the
Installation section of this
manual.)
13- ENG
Risk of Unsafe
Operation. Serious
A05051