Husky Y1010 Manual Del Operador página 9

Unpacking
1. Remove unit from carton and
discard all packaging. NOTE:
Save all parts bags.
Assemble Hose
1. Assemble hose to air outlet.
IMPORTANT: The hex fitting on
the air outlet MUST be held in
place with a wrench when
tightening hose onto air outlet.
Assemble Accessories
The unit is supplied with an
accessory kit and inflator/deflator kit,
choose the accessory needed.
Assemble Accessory Kit
g
e
f
h
d
To Assemble Female Tire Chuck
1. Assemble female tire chuck (a) to
hose (b) and tighten securely
with wrenches.
To Assemble Accessories
1. Attach the blow gun (c) to hose (b).
accessory is not being used with
the blow gun, the safety nozzle
MUST be assembled.
a
c
Risk of unsafe
operation. If an
Safety Nozzle
2. Assemble the safety nozzle (d),
tapered inflator (g), rubber blow
gun tip (h), or blow gun adapter
(e) to blow gun. NOTE: To use
the inflating needle (f) the blow
gun adapter has to be
assembled to blow gun.
3. Attach the inflating needle (f) to
the blow gun adapter on the
blow gun.
Assemble Inflator/Deflator Kit
h
j
k
The blow gun (c) and blow gun
adapter (e) from the accessory kit is
b
needed to use the inflator/deflator kit.
1. Attach the blow gun to hose.
2. Attach blow gun adapter to blow
gun.
3. Attach the inflating needle (h),
tapered nozzle (j), or high flow
inflator/deflator body (k) to the
blow gun adapter on the blow
gun.
4. If using the inflator/deflator
choose the nozzle needed and
see the "How to use High Flow
Inflator/Deflator Adapter Body"
instructions in the Operation
section for the correct procedure.
9- ENG
e
c
A05051