Battery Level Indicator; Battery Replacement - PELI 7070R Manual De Instrucciones

2. P lug the USB end into a USB power
outlet (1A output minimum).
The charge status LED will illuminate
solid red once connected to power.
See Image #4
3. S lide the light into the charger base
aligning the two indicating lines.
See Image #5
4. T he 7070R incorporates wireless charging
and does not utilize direct contacts.
Once aligned properly the charge indicator
will provide a flashing red LED. Once charge
is completed the flashing red LED will
change to solid green. There is also
a "Fault Mode" provided that indicates
an error, such as attempting to charge
with disposable CR123 batteries installed.
5. I f a secure attachment is required, push the light body back into the charger base and the
light will lock into place.
Charger Mounting:
The charger base can be attached to any surface with (2)
size 8 or size 10 screws (not included) through the mounting
holes located in the back of the charger base. See Image #6.
The charger base back will need to be pulled away from the
charging cradle to gain access to the mounting holes.
There is no need to fully discharge the 7070R before charging
the battery. Charging can occur whenever required and the
7070R can be left indefinitely in the charger housing without
fear of over-charging.

Battery Level Indicator:

The forward switch boot houses a built in battery level indicator LED.
The indicator is illuminated whenever the light is activated. The battery level information
is represented as follows:
See Image #7
Green = 100% - 75%
Yellow = 75% - 50%
Red = 50% - 25%
Flashing Red = 25% - 0%
Note: The main LED "blinks" every
5 minutes once the battery level drops
below 25%.

Battery Replacement

When the rechargeable LI-ION battery
requires replacement, unscrew the shroud
and pull the lamp module/battery tray from
the light body to access the battery.
Remove the used battery. Replace the
used battery with a new battery. Replacement batteries are available wherever
Peli Torchs are sold or directly from Peli Products Customer Service.
The 7070R is able to use (2) disposable CR123 lithium batteries with the included battery
tube if recharging is not available. Note: CR123 batteries are not able to be charged.
NOTE: Please act responsibly when disposing of the LI-ION Battery Stick. This part is recyclable and should not be
disposed of in the municipal waste system. Please check with your local waste disposal authority for information.
O-ring Maintenance
Check closely for cuts, scratches, or otherwise damaged O-ring or mating lens lip surface.
Remove any dirt or foreign matter from O-ring sealing surfaces. Keep threads, O-ring groove
and inside lip of lens lubricated with silicone grease.
Battery Safety Information
WARNING: HANDLE AND STORE BATTERIES PROPERLY TO AVOID INJURY
OR DAMAGE BATTERIES CAN BE DANGEROUS!
Most battery issues arise from improper handling of batteries, and particularly from the use of damaged
or counterfeit batteries. Please review the information below to avoid serious injury and/or damage to
your property.
Rechargeable Batteries
1. H azardous location safety approvals for explosive environments are only valid for the Peli battery
pack that is supplied with the light.
2. F or replacement battery packs only use the approved Peli battery pack for the model of the light that
you are using. The use of other battery packs will invalidate the safety approval.
3. Lights should only be charged in a non-hazardous location.
4. L ights should only be charged using the Peli charger base that is supplied with the light.
5. L ights should be charged and operated between the temperatures shown: Charge Temperature:
-20°C to 50°C (-4°F to 122°F)
Operating Temperature: -20°C to 50°C (-4°F to 122°F).
6. D o not charge with alkaline batteries installed in the light. Attempting this can cause internal gas or
heat generation resulting in venting, explosion or possibly fire.
7. D eep discharge of the rechargeable battery may cause batteries to vent potentially dangerous
gasses and electrolytes.
Always dispose of all batteries properly at an approved battery recycling center.
4
5
6
7