Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
010820
3.
Always wear a helmet where there is a risk of
falling objects. The protective helmet is to be
checked at regular intervals for damage and is to
be replaced at least every five years. Use only
approved protective helmets.
4.
The visor of the helmet (or alternatively goggles)
protects the face from flying debris and stones.
During operation of the tool always wear goggles,
or a visor to prevent eye injuries.
5.
Wear adequate noise protection equipment to avoid
hearing impairment (ear muffs , ear plugs etc.).
010821
6.
Work overalls protect against flying stones and
debris. It is strongly recommended that the user
wears work overalls.
7.
Special gloves made of thick leather are part of the
prescribed equipment and must always be worn
during operation of the tool.
8.
When using the tool, always wear sturdy shoes
with a nonslip sole. This protects against injuries
and ensures a good footing.
Electrical and battery safety
1.
Avoid dangerous environment. Don't use the tool
in damp or wet locations or expose it to rain. Water
entering the tool will increase the risk of electric
shock.
2.
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one
type of battery pack may create a risk of fire when
used with another battery pack.
3.
Use power tools only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
4.
When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws or other small metal objects, that can
make a connection from one terminal to another.
Shorting the battery terminals together may cause
burns or a fire.
5.
Under abusive conditions, liquid may be ejected
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, seek medical help. Liquid ejected
from the battery may cause irritation or burns.
6.
Do not dispose of the battery(ies) in a fire. The cell
may explode. Check with local codes for possible
special disposal instructions.
7.
Do not open or mutilate the battery(ies). Released
electrolyte is corrosive and may cause damage to
the eyes or skin. It may be toxic if swallowed.
Starting up the tool
360°
012858
1.
Make sure that there are no children or other
people within a working range of 15 meters (50 ft),
also pay attention to any animals in the working
vicinity. Otherwise stop using the tool.
2.
Before use always check that the tool is safe for
operation. Check the security of the nylon cutting
head and the guard and the switch trigger/lever for
easy and proper action. Check for clean and dry
handles and test the on/off function of the switch.
3.
Check damaged parts before further use of the tool.
A guard or other part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. Check
for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other
condition that may affect its operation. A guard or
other part that is damaged should be properly
repaired or replaced by our authorized service
center unless indicated elsewhere in this manual.
4.
Switch on the motor only when hands and feet are
away from the nylon cutting head.
5.
Before starting make sure that the nylon cutting
head has no contact with hard objects such as
branches, stones etc. as the nylon cutting head
will revolve when starting.
3
Publicidad
Tabla de contenido
