Important Safety Information; Key To Symbols; Safety Precautions - Epson TM-T70II Manual Del Usuario

Important Safety Information

This section presents important information intended to ensure safe and effective
use of this product. Read this section carefully and store it in an accessible location.

Key to Symbols

The symbols in this manual are identified by their level of importance, as defined
below. Read the following carefully before handling the product.
WARNING:
Warnings must be observed carefully to avoid serious bodily injury.
CAUTION:
Cautions must be observed to avoid minor injury to yourself, damage to your
equipment, or loss of data.

Safety Precautions

This section describes the warnings and cautions intended to ensure safe and
effective use of the TM-T70II. Other warnings and cautions on handling of this
product for its safe and effective use are described in other sections of the manual.
WARNING:
If the TM-T70II produces smoke, a strange odor, or unusual noise, shut down the
TM-T70II, unplug the AC cable immediately, and then contact your dealer or an
Epson service center for advice. Continued use may lead to fire or electric
shock.
Never attempt to repair this product yourself. Improper repair work can be
dangerous.
Never disassemble or modify this product. Tampering with this product may
result in injury or fire.
Be sure to use the specified power source. Connection to an improper power
source may cause fire.
Do not allow foreign matter to fall into the equipment. Penetration by foreign
objects may lead to fire.
If water or other liquid spills into this equipment, shut down the TM-T70II, unplug
the AC cable of the TM-T70II immediately, and then contact your dealer or an
Epson service center for advice. Continued use may lead to fire or shock.
Do not use aerosol sprayers containing flammable gas inside or around this
product. Doing so may cause fire.
CAUTION:
Do not connect cables in ways other than those mentioned in this manual.
Different connections may cause equipment damage or fire.
Be sure to set this equipment on a firm, stable, horizontal surface. The product
may break or cause injury if it falls.
Do not use this product in locations subject to high humidity or dust levels.
Excessive humidity and dust may cause equipment damage or fire.
Do not place heavy objects on top of this product. Never stand or lean on this
product. Equipment may fall or collapse, causing breakage and possible injury.
Take care not to injure your fingers on the manual cutter
• When you remove printed paper
TM-T70II User's Manual 3
English