Briggs & Stratton Simplicity Guia De Contacto Del Cliente página 4

catalytic converter. Also included may be hoses, belts,
connectors, sensors, and other emissions-related assemblies.
Where a warrantable condition exists, B&S will repair your
engine at no cost to you including diagnosis, parts, and labor.
Manufacturer's Warranty Coverage:
Small off-road engines and large spark ignited engines less
than or equal to 1.0 liter, are warranted for two years, or for the
time period listed in the respective engine or product warranty
statement, whichever is greater. If any emissions-related part
on your B&S engine is defective, the part will be repaired or
replaced by B&S.
Owner's Warranty Responsibilities:
• As the engine owner, you are responsible for the
performance of the required maintenance listed in your
Operator's Manual. B&S recommends that you retain all
receipts covering maintenance on your engine, but B&S
cannot deny warranty solely for the lack of receipts or your
failure to ensure the performance of all scheduled
maintenance.
• As the engine owner, you should however be aware that
B&S may deny you warranty coverage if your engine or a
part has failed due to abuse, neglect, improper maintenance,
or unapproved modifications.
• You are responsible for presenting your engine to a B&S
distribution center, servicing dealer, or other equivalent
entity, as applicable, as soon as a problem exists. The
warranty repairs should be completed in a reasonable
amount of time, not to exceed 30 days. If you have any
questions regarding your warranty rights and responsibilities,
you should contact B&S at 1-800-444-7774 (in USA) or
BRIGGSandSTRATTON.com.
Briggs & Stratton Emissions Control
Warranty Provisions
The following are specific provisions relative to your Emissions
Control Warranty Coverage. It is in addition to the B&S engine
warranty for non-regulated engines found in the Operator's
Manual.
1. Warranted Emissions Parts
Coverage under this warranty extends only to the parts listed
below (the emissions control systems parts) to the extent these
parts were present on the B&S engine.
a. Fuel Metering System
• Cold start enrichment system (soft choke)
• Carburetor or fuel injection system
• Oxygen sensor
• Electronic control unit
• Fuel pump module
b. Air Induction System
• Air cleaner
• Intake manifold
4
c. Ignition System
• Spark plug(s)
• Magneto ignition system
d. Catalyst System
• Catalytic converter
• Exhaust manifold
• Air injection system or pulse valve
e. Miscellaneous Items Used in Above Systems
• Vacuum, temperature, position, time sensitive valves and
switches
• Connectors and assemblies
2. Length of Coverage
Coverage is for a period of two years from the date of original
purchase, or for the time period listed in the respective engine
or product warranty statement, whichever is greater. B&S
warrants to the original purchaser and each subsequent
purchaser that the engine is designed, built, and equipped so
as to conform with all applicable regulations adopted by the Air
Resources Board; that it is free from defects in material and
workmanship that could cause the failure of a warranted part;
and that it is identical in all material respects to the engine
described in the manufacturer's application for certification. The
warranty period begins on the date the engine is originally
purchased.
The warranty on emissions-related parts is as follows:
• Any warranted part that is not scheduled for replacement
as required maintenance in the Operator's Manual supplied,
is warranted for the warranty period stated above. If any
such part fails during the period of warranty coverage, the
part will be repaired or replaced by B&S at no charge to the
owner. Any such part repaired or replaced under the
warranty will be warranted for the remaining warranty period.
• Any warranted part that is scheduled only for regular
inspection in the Operator's Manual supplied, is warranted
for the warranty period stated above. Any such part repaired
or replaced under warranty will be warranted for the
remaining warranty period.
• Any warranted part that is scheduled for replacement as
required maintenance in the Operators's Manual supplied,
is warranted for the period of time prior to the first scheduled
replacement point for that part. If the part fails prior to the
first scheduled replacement, the part will be repaired or
replaced by B&S at no charge to the owner. Any such part
repaired or replaced under warranty will be warranted for
the remainder of the period prior to the first scheduled
replacement point for the part.
• Add-on or modified parts that are not exempted by the Air
Resources Board may not be used. The use of any
non-exempted add-on or modified parts by the owner will
be grounds for disallowing a warranty claim. The
manufacturer will not be liable to warrant failures of
warranted parts caused by the use of a non-exempted
add-on or modified part.
simplicitymfg.com