Troubleshooting - Dexter DX216 Manual Del Usuario

14. Troubleshooting

Fault Possible cause
Motor does not work Motor, cable or plug defective, the mains
circuit breaker switched off
The motor starts Voltage too low, coils damaged, capacitor
up slowly and does burnt
not reach operating
speed.
Motor makes exces- Coils damaged, motor defective
sive noise
The motor does not Circuits in the network are overloaded
reach its full power. (lamps, other motors, etc.)
Motor overheats Overloading of the motor, insufficient cool-
easily. ing of the motor
Saw cut is rough or Saw blade dull, tooth shape not appropriate
wavy for the material thickness
Workpiece pulls away Excessive cutting pressure and/or saw
and/or splinters blade not suitable for use
GUARANTEE:
Thank you for investing in a ADEO power tool. These products have been made to demanding, high-quality standards
and are guaranteed for domestic use against manufacturing faults for a period of 24 months from the date of purchase.
This guarantee does not affect your statutory rights. In case of any malfunction of your tool (failure, missing part, etc.),
please contact service.
Service address: ADEO's Service address: 135 RUE SADI CARNOT CS00001, 59790 RONCHIN, FRANCE
Normal wear and tear, including accessory wear, is not covered under guarantee. The product is guaranteed for 24
months if used for normal demostic use. Any guarantee is invalid if the product has been overloaded or subject to ne-
glect, improper use or an attempted repair other than by an authorized agent. Heavy-duty, daily professional or hire
usage are not guaranteed. Due to continuous product improvement, we reserve the right to change the product spec-
ification without prior notice.
34 | GB
Remedy
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by
a specialist
Arrange for inspection of the motor by a special-
ist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Re-sharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade