Maintenance; Daily; Periodically Or After A Period Of Intensive Machine Use; Tank Cleaning - Rancilio MISS LUCY Uso Y Manutención

9. MAINTENANCE

The maintenance operations must be carried
out with the machine off and cold and with
the power plug disconnected.
Do not use any metallic or abrasive materials
for cleaning such as scourers, metal brushes,
needles and detergents but use a damp cloth
or sponge.

9.1. Daily

 Clean the bodywork, the steam pipe 7, the spray
element 19 and the cup-base seal 21 of unit 20.
 Check and clean the discharge drawer 10 as re-
quired.
 Rinse filters 22/23 and the filter-holder 12 using
hot water and a cloth or sponge.
9.2. Periodically or after a period of intensive
machine use
As well as the daily operations undertake the fol-
lowing operations:
 Immerse filters 22/23 and the filter-holder 12 in
boiling water for a few minutes to allow the coffee
grease to dissolve, then remove using a sponge
or a cloth.
 Regularly empty the granulated coffee container
and clean out to remove any oily deposits left by
the coffee.
 Periodically use the special scale removing pro-
ducts for "family coffee making machines" which
are to be added to the water during operation.
Carefully follow the instructions on the scale
remover packaging. For information concer-
ning the choice of the scale removal product
contact specialized personnel or the assi-
stance service.

9.3. Tank cleaning

(Fig. 7-8)
A) Resin regeneration:
 Dissolve three teaspoonfuls of salt in a glass of
water.
 Extract the softener "A" from the rubber pipe "C",
turn it over and pour the salted water through the
filter allowing it to flow freely (1).
 Wait about 5 minutes, place the softener under the
running water tap and rinse (2).
When the water that comes out of the softener is
no longer salted, the resins have been regenerated
and the softener is ready.
40
B) Tank cleaning:
 Clean the water tank 8
 Pour about 2 litres of water into the tank (using
drinking water preferably softened).
 Close the lid making sure that pipe "D" and softener
"A" touch the bottom of the tank.
 Switch on the machine using switch 1.
After having carried out these operations to
re-start the machine repeat the operations
as described in the chapter entitled "Starting
up point C"

9.4. Special maintenance

 All the maintenance operations not described in
the previous points are the responsibility of the
assistance service.