General Safety Instructions; Inserting Batteries - LaserLiner LaserCube Manual De Instrucciones

Read the operating instructions and the enclosed brochure
!
„Guarantee and additional notices" completely. Follow the
instructions they contain. Safely keep these documents for
future reference.
Line laser for alignment work on the ground and on
walls.

General safety instructions

Caution: Do not look directly into the beam. Lasers must be kept
out of reach of children. Never intentionally aim the device at people.
This is a quality laser measuring device and is 100% factory adjusted
within the stated tolerance. For reasons of product liability, we must
also draw your attention to the following: Regularly check the cali-
bration before use, after transport and after extended periods of
storage. We also wish to point out that absolute calibration is only
possible in a specialist workshop. Calibration by yourself is only
approximate and the accuracy of the calibration will depend on
the care with which you proceed.
1

Inserting batteries

Open the battery compartment
and insert batteries according
to the symbols. Be sure to pay
attention to polarity.
1
2
04
GB
Laser radiation!
Do not stare into the beam!
Class 2 laser
< 1 mw · 650 nm
EN 60825-1:2007-10
4
3
1 Laser output windows
2 Battery compartment
(bottom)
3
ON / OFF switch
4 Vials
–