Charging Procedure - Motorola Solutions PMPN4156 Guia De Inicio Rapido

OPERATING INSTRUCTIONS
• Batteries charge best at room temperature.
• Batteries to be attached to a radio or stand-alone.

CHARGING PROCEDURE

Figure 2: Inserting Radio with Battery or Stand-alone Battery
1. Place the Multi-Unit Charger (MUC) on a flat surface.
2. Firmly insert the power supply into the charger DC Inlet Socket at the back of the
charger.
3. Plug the power supply power cord into a matching power outlet.
4. Upon successful power-up, each pocket LED shows Green for one second and IMPRES
2 CHARGER is displayed. If the LEDs do not flash and no message is displayed, check
power cord connections.
5. Insert the radio with battery or stand-alone battery into an available pocket.
6. When the radio or stand-alone battery is properly seated in the pocket:
- Charging status of a radio is indicated by the LED Status Indicator and/or display of
the radio.
- Charging status of a stand-alone battery is indicated by the LED Status Indicator of the
associated pocket on the MUC.
- The Display of the MUC shows the charging status of Pocket 1 only.
7. The radio or stand-alone battery is ready for use when the LED is Steady Green.
8. You can only turn the radio on while charging when the Communications Module is
detached from the charger. Otherwise, turn off the radio.
Note: Grip the radio body when inserting or removing the radio from the charger.
Avoid pulling the radio antenna when removing the radio.
4