Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the vehicles tail
light wiring harness behind the
rear bumper. The harness will
be located along the inside of
the left (drivers) side frame
rail and will have connectors
similar to those on the
T-Connector harness (Fig. 1).
3. Separate the vehicle connectors, taking
care not to damage the locking tabs. Inspect the
connectors for dirt & debris and clean if necessary.
4. Position the T-Connector harness between the
separated vehicle harness connectors.
Press the T-Connector ends firmly into the vehicle
harness connectors until they lock into place. Take care
not to damage the locking tabs.
5. Confirm correct operation with a test light or by
using a properly equipped trailer.
6. Route the 4-flat connector to the center of the
vehicle and secure using a cable tie (provided).
Fig. 1
Publicidad
