Call Customer Service; Replacement Parts - Weber PULSE 2000 Manual Del Propietário

WARNING
m
Do not attempt to make any
m
repair to electric components or
structural components without
contacting Weber-Stephen
Products LLC, Customer Services
Department.
Failure to use genuine Weber-
m
Stephen parts for any repair or
replacement will void all warranty
protection.
CALL
CUSTOMER
SERVICE
If you are still experiencing any
problems, contact the Customer Service
Representative in your area using the
contact information that can be
found on weber.com.
REPLACEMENT
PARTS
To obtain replacement parts,
contact the local retailer in your
area or log onto weber.com.
14
ELECTRIC GRILL DOES NOT TURN ON
SYMPTOM
• Heating element does not heat when following the instructions in the 'Operation' section
of this Owner's Manual.
CAUSE
The temperature controller may not be properly
inserted into the housing.
There is a problem with the power flowing from the
socket.
The GFI safety device that is built-in to the temperature
controller may have interrupted the power to the grill.
ERROR CODE APPEARS ON DISPLAY
SYMPTOM
• During start-up or barbecuing, an error code appears on the digital display.
CAUSE
The temperature controller is a device that is sensitive
to certain external factors. Variations in power supply
or radio frequency may affect operation.
ELECTRIC GRILL IS EXPERIENCING CONNECTIVITY ISSUES
SYMPTOM
• Wi-Fi is having trouble maintaining connectivity with a Wi-Fi network.
CAUSE
Grill is out of range of the Wi-Fi network signal.
SYMPTOM
• Bluetooth® is having trouble maintaining connectivity or pairing with a smart device.
CAUSE
Bluetooth® is a short range signal only.
Bluetooth® has already paired to another smart device.
SOLUTION
Remove and reinstall temperature controller.
Always plug the temperature controller into the grill
before plugging power cable into the socket.
Check the electrical power supply.
If the digital thermometer display and the temperature
status indicator light(s) are not on, move the red power
button on the temperature controller to the OFF position
in order to 'reset' the GFI safety device. Wait 30 seconds,
then move the red power button to the ON position.
SOLUTION
First, turn the temperature controller off using the
red power button. Unplug the power cable from
the power outlet and remove the temperature
controller from the grill.
Wait 30 seconds, then attach the temperature
controller fully onto the grill before plugging the
power cable into the outlet. Move the red power
button to the ON position.
SOLUTION
In order to successfully connect your smart device
to your local Wi-Fi network, your grill must be
within range of your Wi-Fi router. If your attempts to
connect have been unsuccessful, try moving the grill
within range of the Wi-Fi router or adding a signal
extender for a stronger signal.
SOLUTION
When the temperature controller is on, it is ready to
pair. Make sure that Bluetooth® on the smart device
is turned on and that the device is near the grill.
If the Bluetooth® indicator light is on but is not
flashing, it means that it is already paired to a smart
device. Turn off Bluetooth® on any smart device that
you do not wish to have paired to the grill.
DON'T FORGET TO REGISTER