Remington HC5780 Manual Del Usuario página 5

ENGLISH
Comb Position
, TO ATTACH A COMB
• Hold the comb with its teeth upward
• Slide it onto and along the clipper blade until the front of the comb firmly sits against the
clipper blade.
, TO REMOVE THE COMB
• Holding the clipper with the blades facing away from you, firmly push the comb upward
and away from the blades.
F INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the hair. Do not
force it through quickly. If you are cutting for the first time, start with the maximum comb
attachment
STEP 1 – Nape of the neck
• Set the comb to 3mm or 6mm.
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of
the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time
STEP 2 – Back of the head
• With the comb set at 12mm or 18mm, cut the hair at the back of the head.
STEP 3 – Side of the head
• Set the comb to 3mm or 6mm, trim sideburns. Then change the setting to 9mm and
continue to cut the top of the head.
HC5780 -INT-T22-amended.indd 5
Short Comb
1 3mm
2 6mm
3 9mm
4 12mm
5 15mm
6 18mm
7 21mm
Long Comb
24mm
27mm
30mm
33mm
36mm
39mm
42mm
5
11/19/2012 12:09:36 PM