Remington HC5780 Manual Del Usuario página 6

ENGLISH
STEP 4 – Top of the head
• Use the longer length comb attachment and set it to 24mm or 27mm then cut hair on
top of the head against the direction in which the hair normally grows.
• For longer hair on top, use the longer length comb attachment (24 – 42mm) to achieve
the desired style.
• Always work from the back of the head.
STEP 5 – The finishing touches
• Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin
and then work downwards.
, SHORT TAPERED STYLES – "FLAT TOPS" & SHORT CUTS
• Starting with the longest guide comb attached (24 - 42mm), cut from the back of the
neck to the crown. Hold the guide comb flat against the head and slowly move the
clipper through the hair.
• Use the same procedure from the lower side to the upper side of the head. Then cut the
hair against the direction in which it grows and level with the sides.
• To give a "flat top" look, the hair on top of the head must be cut over the top of a flat
comb.
• Use a closer guide comb to taper the hair down to the neckline as desired.
F HAIR TEXTURE MECHANISM
• Simply adjust the hair texture mechanism by sliding the button at the top of the hair
clipper.
• Blending different length areas - Select the proper length guard to blend. Slide out the
hair texture mechanism (guard) which allows you to blend / thin out the area.
• Textured cut – Slide out the hair texture mechanism (guard) to give an all over textured
cut.
F DUAL BOOST SYSTEM
• There are 3 settings for the Dual Boost system: Off, On, Boost.
• If the clipper is set to on, it will run at regular power.
• If the clipper is set to boost, it will provide maximum power.
C CARE FOR YOUR APPLIANCE
Your clipper is fitted with high quality blades.
To ensure long lasting performance of your clipper, clean the blades and unit regularly.
Always keep the attachment guide comb on the trimmer blade.
6
HC5780 -INT-T22-amended.indd 6 11/19/2012 12:09:36 PM