Toshiba dynadock U3.0 Manual Del Usuario página 25

Resolution
640 x 480
720 x 400
800 x 600
832 x 624
848 x 480
1024 x 768
1152 x 864
1152 x 870
1280 x 720
1280 x 768
1280 x 800
Note that interlaced modes are not supported and the resolutions listed
above may not be supported by your monitor.
Additional modes may be offered, depending upon the connected monitor,
but these are not currently guaranteed.
If the monitor does not advertise the supported modes, the HDMI
VGA component will choose a set of common screen modes.
If cloning the primary display, the HDMI
use the preferred monitor mode. In some cases, this may not be the most
appropriate mode for the mirrored desktop. It is recommended that the
primary display resolution be changed to closer match the default
resolution of the dynadock monitor.
For more information on supported modes, be sure to check the
NOTE
documentation supplied with your monitor.
When the HDMI
primary monitor. Changes to the screen mode and HDMI
component operation mode can be made under the Windows display
properties. If no output is seen on the monitor connected to the HDMI
DVI-I/VGA component, it may be in a mode which cannot be displayed by
the monitor. This can happen if the monitor does not report its supported
modes to the HDMI
the primary display, and in turn the resolution of the HDMI
component display until an image is shown.
Placing the monitor into an unsupported mode for long periods can
NOTE
damage it.
User's Manual
Refresh Rates (Hz)
60, 67, 72, 75, 85
70, 85, 88
56, 60, 72, 75, 85
75
60
60, 70, 75, 85
75
75
50, 60
60, 75, 85
60
®
or DVI-I/VGA component first starts, it will extend the
®
or DVI-I/VGA component. Reduce the resolution of
Resolution Refresh Rates (Hz)
1280 x 960 60, 85
1280 x 1024 60, 75
1360 x 768 60
1366 x 768 50, 60
1368 x 768 60
1400 x 1050 60, 75, 85
1440 x 900 60
1600 x 1200 60
1680 x 1050 60
1920 x 1080 50, 60
2048 x 1152 60
® or DVI-I/VGA component will try to
dynadock™ U3.0
®
or DVI-I/
®
or DVI-I/VGA
®
or
®
or DVI-I/VGA
EN-25