General Description - Cebora PLASMA PROF 123 ACC Manual De Instrucciones

The following numbered text corresponds to the label
numbered boxes.
1. Cutting sparks can cause explosion or fi re.
1.1 Keep fl ammable materials away from cutting.
1.2 Cutting sparks can cause fi res. Have a fi re extin-
guisher nearby, and have a watchperson ready to
use it.
1.3 Do not cut on drums or any closed container.
2. The plasma arc can cause injury and burns.
2.1 Turn off power before disassembling torch.
2.2 Do not grip material near cutting path.
2.3 Wear complete body protection.
3. Electric shock from torch or wiring can kill.
3.1 Wear dry insulating gloves. Do not wear wet or dam-
aged gloves.
3.2 Protect yourself from electric shock by insulating
yourself from work and ground.
3.3 Disconnect input plug or power before working on
machine.
4 Breathing cutting fumes can be hazardous to your
health.
4.1 Keep your head out of fumes.
4.2 Use forced ventilation or local exhaust to remove
fumes.
4.3 Use ventilating fan to remove fumes.
5 Arc rays can burn eyes and injure skin.
5.1 Wear hat and safety glasses. Use ear protection and
button shirt collar. Use welding helmet with correct
shade of fi lter. Wear complete body protection.
6 Become trained and read the instructions before
working on the machine or cutting.
7 Do not remove or paint over (cover) the label.

2 GENERAL DESCRIPTION

This equipment is a direct current continuous power
source designed for plasma arc cutting of electro-con-
ducting materials (metals and alloys). The plasma gas
can be air or nitrogen.
2.1 UNPACKING AND ASSEMBLY
Remove the packing material from the equipment, screw
the three eyebolts provided and lift as indicated in Fig. 1.
Since this machine is equipped with wheels without
brake, make sure the machine is not positioned on slop-
ing planes, to avoid tilting or noncontrolled motion of the
machine itself.
10
2.2 DESCRIPTION OF THE EQUIPMENT (fi g. 2)
A) Function switch 0-1.
C) Fixed fi tting for the welding torch.
D) Welding torch coupling protection.
E) Socket for earth cable.
F) Mobile fi tting.
H) Knob for adjusting gas pressure.
I) Gas supply fi tting (1/4" gas female thread).
J) Condensation collecting tray.
K) Power cord.
L) Pressure gauge.
N) Cutting mode LED.
O) Self Restart mode LED (pilot arc automatic restart).
P) Gouging mode LED.
U) Display that shows:
- at start-up = machine code (956), torch
type (CP161 or CP101), torch length (Len).
- otherwise = cutting current and error codes.
V) Display that shows:
- at start-up = software version (01, 02, ...), torch
type (CP), torch length (6)
otherwise = nozzle diameter and error codes.
W) Operating mode selector Every time this push-button
is pressed the corresponding LED lights.
Z) Knob to adjust the cutting current.
2.3 EXPLANATION OF THE TECHNICAL SPECIFICA-
TIONS LISTED ON THE MACHINE PLATE.
The equipment is manufactured according to these
international standards: IEC 60974.1 - IEC 60974.3 -IEC
60974.10 CL. A - IEC 61000-3-11 - IEC 61000-3-12 (See
note 2).
Fig. 1